Curley switchpod pics
Turbo Mini Forums

Hi, has anyone got any decent pics of a Curley switchpod dash fitted?

I'm in the process of fitting one, but didn't want to chop too much before seeing one in a car. I've got the ends trimmed nicely, but at the moment it looks like the top is completely the wrong angle.

Thanks in advance.

In the 13's at last!.. Just

the square boxey one?

"Turbo's make torque, and torque makes fun"

"did you know you can toast potato waffles?"

That's the one. Do you know if that car has the top rail fitted?

At the moment with the ends nearly meeting the top rail, the middle is over an inch higher.

In the 13's at last!.. Just

it does yeah

"Turbo's make torque, and torque makes fun"

"did you know you can toast potato waffles?"

wont it flex down if you trim the ends a bit? mines right thin and floppy

"Turbo's make torque, and torque makes fun"

"did you know you can toast potato waffles?"

Hmmm, I'll just keep trimming then.

Those pics are a help. Thanks joe

In the 13's at last!.. Just

Oh, one last question. Does the face of the dash meet the original rails or does it sit further forward?

In the 13's at last!.. Just

That's got to warrant a sig! Lol

In the 13's at last!.. Just

alot further forward, prob 3 or 4" i think

"Turbo's make torque, and torque makes fun"

"did you know you can toast potato waffles?"

iv got a similar styled one in fibreglass

i had to do alot of fettling to get mine in, mainly because i have a weld in cage which i had to trim the dash to dodge it.
mine was sitting high in the centre too so as said i just boled it in, can hardly notice it when the screens in anyway

David.

Cool thanks guys!

In the 13's at last!.. Just

Thats all thats left of mine.lol

Rick

Bloody hell! You have to lighten everything I suppose.

In the 13's at last!.. Just

Got there in the end. Thanks for your help guys.

In the 13's at last!.. Just

nice pluggable connector blocks lol.

Yes, thanks for those Joe. I'd not seem them before and they work a treat.

In the 13's at last!.. Just

i see there's no demister vents,

are you ditching the heater?

i see you've got an AFR gauge too.

sorted out a speedo/tacho yet?

The heater is staying put, but I'm not sure about the demisters yet. I was just going to tuck it down the back of the dash. Relocating the switch to the front of the dash and omitting the 'selector thingy'.

I'll be purchasing an Acewell at some point, but need to save the pennies first.

AFR gauge is an eBay jobbie about £40. I scrapped the volt meter when I got the dash.

In the 13's at last!.. Just

how much are these dashes from curley?
ive looked on his webistie and theres no price

I think it's about £160ish. Sorry I can't sure as I bought it secondhand.

In the 13's at last!.. Just

Little update on this...

Switches...


only took all day to do this and wire in the lc1!

In the 13's at last!.. Just

this makes my cock hard...


where did you get the name plate, looks ace.

Edited by Joe C on 15th May, 2010.

Lol! You are easily aroused!

It's just printed on some glossy paper with double sided tape to hold it in place. It means I can replce it relativly easily if I swap any switches around.

In the 13's at last!.. Just

I hope that hazard light LED flashes, otherwise its an MOT fail.

Looks top notch that does!