| Page: |
| Home > Help Needed / General Tech Chat > Top arm bearings | |||||||
 16540 Posts Member #: 4241 King Gaycharger, butt plug dealer, Sheldon Cooper and a BAC but generally a niceish fella if you dont mind a northerner Rotherham, South Yorkshire |
22nd Mar, 2012 at 09:18:06pm
I'll give it a go when I get that far On 11th Feb, 2015 robert said:
i tried putting soap on it , and heating it to brown , then slathered my new lube on it 
|
||||||
 690 Posts Member #: 1851 Post Whore Woolavington, Zummerzet |
25th Mar, 2012 at 11:33:03am
http://www.youtube.com/watch?v=ralN9XdCdQk
Edited by Alex on 25th Mar, 2012. Metric is for people who can't do fractions. |
||||||
|
1909 Posts Member #: 9764 Post Whore Northamptonshire. |
25th Mar, 2012 at 11:39:38am
I stuck the arm in the vice and used the old shaft ground off at the end to get it to sit on the bearing then gave it a good few taps then back in used the 20 tonne press at college :) |
||||||
|
16540 Posts Member #: 4241 King Gaycharger, butt plug dealer, Sheldon Cooper and a BAC but generally a niceish fella if you dont mind a northerner Rotherham, South Yorkshire |
25th Mar, 2012 at 01:32:42pm
On 25th Mar, 2012 Alex said:
http://www.youtube.com/watch?v=ralN9XdCdQk That looks easy enough to make. On 11th Feb, 2015 robert said:
i tried putting soap on it , and heating it to brown , then slathered my new lube on it
|
||||||
 8297 Posts Member #: 408 Turbo Love Palace Fool Aylesbury |
25th Mar, 2012 at 06:44:54pm
Ive got to do this job soon too, unless square needle rollers are the norm? lol
https://www.facebook.com/pages/Fusion-Fabri..._homepage_panel
|
||||||
| Home > Help Needed / General Tech Chat > Top arm bearings | |||||||
|
|||||||
| Page: |