Page:
Home > Help Needed / General Tech Chat > Kad internal gear linkage

Oli

User Avatar

1733 Posts
Member #: 1910
Post Whore

Wilts

23rd Apr, 2017 at 03:50:49pm

Guys just had my engine out for some maintenance,

Dropped it back in, trying to reset the linkage and I cannot get 1st or 3rd at all, never had a problem before.

Only thing I've changed is I've got a bolt instead of a roll pin?

Any advice?

On 15th Jul, 2009 fastcarl said:
 the pissed up clown stood back up, did a twirl and left bollock naked,


madmk1

User Avatar

5417 Posts
Member #: 6181
Double hard bastard

brookwood woking

23rd Apr, 2017 at 09:08:40pm

Have you set the engine stays to the same as before?

I have had this happen before to me, after pulling it out and then back in, I have not set the rose joint to the same as before.

I have started posting on Instagram also my name on there is turbomk1golf

Nothing is impossible it just costs more and takes longer.

On 1st Nov, 2007 Ben H said:
There is no such thing as 'insignificant weight saving', it all adds up.


Oli

User Avatar

1733 Posts
Member #: 1910
Post Whore

Wilts

23rd Apr, 2017 at 09:42:11pm

Yeah all the engine stays were the same, took me four hours in the end,

Happened to be a tiny little window where I could get all the gears, never have I had problems like that before

On 15th Jul, 2009 fastcarl said:
 the pissed up clown stood back up, did a twirl and left bollock naked,

Home > Help Needed / General Tech Chat > Kad internal gear linkage
Users viewing this thread: none. (+ 1 Guests) <- Prev  
To post messages you must be logged in!
Username: Password:
Page: