Head Mods
Turbo Mini Forums

Can't you just modify the cluch cover (the wok) such that you can index it round clockwise and mount the slave cyl on the coil bracket lugs at the front of the transfer case?

Now theres a good idea (as always!) from Dave. Or you could maybe make use of the three tapped holes on the rear of the transfer case that are used for the metro engine mounting?

Edit- Argh I see you've already used those for a turbo support bracket.........

Edited by Tom Fenton on 6th Jun, 2005.

I have been looking at moving the cover round as dave said and using the front coil mounting.

That is looking to be the easiest. Cut the starter part off the cover turn the cover round on the normal bolt holes and weld the starter bit back on where it needs to be

Here's a pic of the Janspeed affair, if it's any use to anybody.

Phil.

WWW.TURBO-MINI.COM

ah ideal had a fair idea of what it was like. Had a closer look at moving the cover round on the bolts turned out that was a no go as this would aslso move the engine mounting with it.

Looks like the janspeed setup or some welding and indexing of the slot for the clutch arm.

Just remembered,some company made hydraulic release bearing used on rwd fords(sort of large dia/short stroke ram with bearing on end)-if it fits then arm not needed at all

Metro turbo weekend driver,Mini turbo in the making again!

ive seen those in the demon twonks catalogue

Good idea, but not that novel - Available on EVERY mondeo if you wanted one on the cheap...

yeah demon tweak is what gave me the idea

Mike, when will it all be ready? is this the cheapy budget thing you are doing with that rover cooper of yours?

Looks very nice, is this why wills gearbox and diff aren't finished yet

Rich

Thats the one lol

Yeah wills gearbox should be done pretty soon. Been busy doing other cars. Extra money and all that