| Page: |
| Home > Help Needed / General Tech Chat > waste gate inside T2 ouletgate | |||||||
|
113 Posts Member #: 1230 Advanced Member |
28th Aug, 2006 at 07:12:37pm
When u make a downpipe for the outlet of the turbo u have the wastegate that opens but how far does it has to go open? because when u open the gate it sticks 2 cm above the edge...
|
||||||
|
Forum Mod 10980 Posts Member #: 17 ***16*** SouthPark, Colorado |
28th Aug, 2006 at 07:37:00pm
I doubt you'd see more than 1/4" axial travel on the actuator rod personally...
Edited by turbodave16v on 28th Aug, 2006. On 17th Nov, 2014 Tom Fenton said:
Sorry to say My Herpes are no better Ready to feel Ancient ??? This is 26 years old as of 2022 https://youtu.be/YQQokcoOzeY |
||||||
|
113 Posts Member #: 1230 Advanced Member |
28th Aug, 2006 at 07:49:08pm
the valve of the wastegate opens completly, so when u attach the downpipe to it, it cannot open completly, or isn't that necessary? thanks http://stefaan-desutter.magix.net/userwebs...omaasp31?act=12 |
||||||
 9258 Posts Member #: 123 Post Whore Betwix Harrogate and York |
28th Aug, 2006 at 07:52:12pm
Dave has already answered this question. When in use it will not open that much. TDs guesstimate looks good to me. Fastest 998 mini in the world? 13.05 1/4 mile 106mph
On 2nd Jan, 2013 fastcarl said:
the design shows a distinct lack of imagination, talk about starting off with a clean sheet of paper, then not bothering to fucking draw on it,lol On 20th Apr, 2012 Paul S said:
I'm mainly concerned about swirl in the runners caused by the tangential entry. |
||||||
|
113 Posts Member #: 1230 Advanced Member |
28th Aug, 2006 at 07:53:55pm
ok thanks a lot |
||||||
| Home > Help Needed / General Tech Chat > waste gate inside T2 ouletgate | |||||||
|
|||||||
| Page: |