Trigger disc setting up the timing?
Turbo Mini Forums

I am going to mount trigger wheel from mini-pulleys.com, So do I need to set up engine timing, As i cannot see it being adjustable on crank. or is there more to it?

jay

no, its ready machined so that the missing tooth is at tdc

you just need to make sure the sensor bracket is in the right place if you make one up-90deg before tdc

I also got the bracket from Tom. It makes it much easier.

just a quick question on this topic,

so as long as you fit the bracket and the crank pulley corectley (missing tooth on crank at tdc, bracket 90deg before tdc)

the timing should be sorted?

Yes but check as there may be a few degrees difference which will need to be accounted for either in the map or if the ECU has compensation a la emerald.

A couple of degrees makes all the difference

Not saying that they're not accurately made btw! just silly not to check.

Bolt both the pulley and bracket on and off you go!

I have checked a few of them and generally they are spot on but worth checking for yourself when fitted to your own engine as where the bracket etc is finally bolted down could make a small variation.

i've got one of toms sensor brackets and it was spot on, even with my timing wheel that was courtesy of doodmeister.

Looks like i should drop Tom a mail then :) Where is the best place to get the megajolt kit? Alex?

yup

Cheers guys. Vrooom, sorry for hijacking the post.

Mark.