| Page: |
| Home > For Sale > low ccr pistons | |||||||
 64 Posts Member #: 695 Advanced Member PORTUGAL-VISEU |
31st Dec, 2006 at 03:54:44pm
i have a 1275 machined hepolite turbo pistons to give low ccr to sell
|
||||||
|
64 Posts Member #: 695 Advanced Member PORTUGAL-VISEU |
31st Dec, 2006 at 03:55:52pm
|
||||||
|
3 Posts Member #: 327 Junior Member |
3rd Jan, 2007 at 02:20:54am
Are these for standard 1275 bore size? Any idea roughly what cr they will give? |
||||||
|
64 Posts Member #: 695 Advanced Member PORTUGAL-VISEU |
3rd Jan, 2007 at 02:28:58pm
yes they are a 1275...and are worked by vmaxscart... |
||||||
 3184 Posts Member #: 628 Post Whore a LIL fishing village on the coast - Newcastle Upon Tyne |
3rd Jan, 2007 at 05:53:12pm
are piston rings available for them ??
On 17th Aug, 2009 Jay#2 said:
I doubt I'll be dipping into the 13's like you did though! |
||||||
|
64 Posts Member #: 695 Advanced Member PORTUGAL-VISEU |
4th Jan, 2007 at 12:15:41pm
yes is easy to find .....but i have in the pistons the rings now......if you want i change the pistons for a avonbar stage 2 cam kit.... |
||||||
 7765 Posts Member #: 74 I pick holes in everything.. Chief ancient post excavator |
4th Jan, 2007 at 01:15:26pm
Have you milled off the crown? On 13th Jul, 2012 Ben H said:
Mine gets in the way a bit, but only when it is up. If it is down it does not cause a problem. |
||||||
|
64 Posts Member #: 695 Advanced Member PORTUGAL-VISEU |
4th Jan, 2007 at 09:25:49pm
i don´t have milled nothing the pistons are worked by vmaxscart but i think so... |
||||||
|
64 Posts Member #: 695 Advanced Member PORTUGAL-VISEU |
6th Jan, 2007 at 09:08:46pm
i already have the piston rings |
||||||
| Home > For Sale > low ccr pistons | |||||||
|
|||||||
| Page: |