Page:
Home > Wanted > Actuator arm with 1/4unf thread

iain
Site Admin

User Avatar

8506 Posts
Member #: 16
Sold the turbo and seeing what the C20XE can do!

Near Lincoln

14th Jan, 2007 at 06:04:08pm

As above chaps *smiley*

Did make one but after fooking about with it i bent it today! oops! and it wasn't too clever anyway as it was one i'd turned from a rough arse piece of steel.

I assume its from a renault 5.

if not i'll have to make a new one.

*smiley*


giallofly

User Avatar

I helped keep this site alive!

4436 Posts
Member #: 164
The Stig..

Newport Pagnell

16th Jan, 2007 at 12:54:12pm

So not a standard item then?

I have plenty of standard ones, all new.

JF.

On 21st Jan, 2011 fastcarl said:

therefore acheiving two things , a sore knob and a beer bellyl

iain
Site Admin

User Avatar

8506 Posts
Member #: 16
Sold the turbo and seeing what the C20XE can do!

Near Lincoln

16th Jan, 2007 at 02:33:00pm

not sure mate. all i know is the thread is 1/4unf on the actuator. its a forge one.

A std one would be ideal length etc, just not sure on the thread, sure that could be got round though...

Rob H

4314 Posts
Member #: 700
Formerly British Open Classic

The West Country

16th Jan, 2007 at 02:36:04pm

Give Forge a ring, they stock a whole load of actuator arms and are relatively helpfully.

Isambard Kingdom Brunel said:
Nothing is impossible if you are an Engineer

iain
Site Admin

User Avatar

8506 Posts
Member #: 16
Sold the turbo and seeing what the C20XE can do!

Near Lincoln

16th Jan, 2007 at 03:03:06pm

i looked at their website and didnt really fancy paying £20 for something i could make *smiley*

Rob H

4314 Posts
Member #: 700
Formerly British Open Classic

The West Country

16th Jan, 2007 at 03:06:04pm

Fair point.

Isambard Kingdom Brunel said:
Nothing is impossible if you are an Engineer
Home > Wanted > Actuator arm with 1/4unf thread
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: