| Page: |
| Home > Help Needed / General Tech Chat > How do i break up the exhaust? | |||||||
 3341 Posts Member #: 218 Post Whore Bingley, West Yorkshire |
19th May, 2004 at 06:52:52pm
How do i break the bit of elbow of the metro turbo exhaust, ive taken the two springs off each side on the join, but i cant seperate them both, im scared of hammering it and i cant get it fully off because a bit of the pipe goes above one of the subframe beams, and that would mean seperating the other join two which is packed with exhaust filling gap stuff.! Previous Engine: 1040cc Morespeed engine, 1275 turbo head T2 Turbo Mirage Manifolds Megajolt
|
||||||
|
Site Admin  8506 Posts Member #: 16 Sold the turbo and seeing what the C20XE can do! Near Lincoln |
21st May, 2004 at 05:17:37pm
DOnt think that ball joint comes apart mate, either take it off at the turbo or take the exhaust system off and move it backwards |
||||||
|
3341 Posts Member #: 218 Post Whore Bingley, West Yorkshire |
21st May, 2004 at 07:17:57pm
I have, in the metro all i have is the full exhaust on, and the pipe coming up from below into the engine bay, just to where you put the clamp on it that holds the turbo to the exhaust. Previous Engine: 1040cc Morespeed engine, 1275 turbo head T2 Turbo Mirage Manifolds Megajolt
|
||||||
|
3341 Posts Member #: 218 Post Whore Bingley, West Yorkshire |
24th May, 2004 at 06:18:40pm
oh i get you now! Do i use the link pipe too in the mini? Previous Engine: 1040cc Morespeed engine, 1275 turbo head T2 Turbo Mirage Manifolds Megajolt
|
||||||
| Home > Help Needed / General Tech Chat > How do i break up the exhaust? | |||||||
|
|||||||
| Page: |