Page:
Home > General Chat > *Idea* oil Spray Bar

Alex1340

User Avatar

902 Posts
Member #: 111
Post Whore

Loughborough

3rd Apr, 2007 at 04:26:25pm

Hi Peeps.

Just had an idea while i should be working... Do you think there is much advantage putting a spray bar in to the rocker cover and pumping oil in at either end and spraying the rockers with oil? Basicly just a copper pipe in the rocker cover with little holes in it. Feed oil to it which could be picked off along with the oil pressure gauge or off the out put of an oil cooler.

good? Bad? No point?

Vegard

User Avatar

7765 Posts
Member #: 74
I pick holes in everything..

Chief ancient post excavator

Norway

3rd Apr, 2007 at 05:01:34pm

Why?

On 13th Jul, 2012 Ben H said:
Mine gets in the way a bit, but only when it is up. If it is down it does not cause a problem.

Alex1340

User Avatar

902 Posts
Member #: 111
Post Whore

Loughborough

3rd Apr, 2007 at 05:03:00pm

Get more oil on to the rocker tips help reduce wear.... .. somthing to do....


Vegard

User Avatar

7765 Posts
Member #: 74
I pick holes in everything..

Chief ancient post excavator

Norway

3rd Apr, 2007 at 05:05:14pm

Well, there is sufficient oil in the rocker shaft lubricating the rockers. What is it that you want to lubricate more?

As far as I can see it, the rocker shaft is infact an oil spray bar.

On 13th Jul, 2012 Ben H said:
Mine gets in the way a bit, but only when it is up. If it is down it does not cause a problem.
Home > General Chat > *Idea* oil Spray Bar
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: