Page:
Home > Help Needed / General Tech Chat > Cuttin' Them Damn Holes

b12

User Avatar

826 Posts
Member #: 247
Post Whore

Kent/Surrey Borders

26th May, 2004 at 11:05:03pm

I am going to cut some holes in the front of my bonnet and mesh behind it so my air filter can glug some nice cold air

Whats the best way ; Using a hole saw ?

Or is there some kinda hole punch you could use

I was thining of about 2" in diameter

steve

TurboLessTosser

PaulM

User Avatar

164 Posts
Member #: 206
Advanced Member

Milton Keynes

27th May, 2004 at 01:52:58pm

Metal Hole saw

9 valves, 4 wheel drive, 3 cylinders, 1 turbo, which got nicked

AlexF2003

5795 Posts
Member #: 80
AFRacing LTD

Newbury, Berks

27th May, 2004 at 02:07:36pm

metal hole saws...

B&Q sell them... you need the type that has an "Arber" (Spell)...


Alex

AlexF

Jimster
Site Admin

User Avatar

9408 Posts
Member #: 58
455bhp per ton
12 sec 1/4 mile road legal mini

Sunny Bridgend, South Wales

27th May, 2004 at 04:03:44pm

or try screwfix.com there a bit cheaper

Team Racing

On 15th May, 2009 TurboDave said:
I think the welsh one has it right!


1st to provide running proof
of turbo twinkie in a car and first to
run a 1/4 in one!!

Is your data backed up?? one extra month free for all Turbo minis members, PM me for detials

mini-marauder

User Avatar

265 Posts
Member #: 68
Senior Member

Coventry

28th May, 2004 at 06:56:08am

A more expensive but neater way to do it is a hole punch like this one here

Sooperdooperturbocooperexpertengineering!

Jimster
Site Admin

User Avatar

9408 Posts
Member #: 58
455bhp per ton
12 sec 1/4 mile road legal mini

Sunny Bridgend, South Wales

28th May, 2004 at 08:50:46am

they are what I used

Team Racing

On 15th May, 2009 TurboDave said:
I think the welsh one has it right!


1st to provide running proof
of turbo twinkie in a car and first to
run a 1/4 in one!!

Is your data backed up?? one extra month free for all Turbo minis members, PM me for detials

PaulM

User Avatar

164 Posts
Member #: 206
Advanced Member

Milton Keynes

28th May, 2004 at 10:41:26am

you can get a hole punch from Ikea, for doing tap holes in sinks but should do the job

9 valves, 4 wheel drive, 3 cylinders, 1 turbo, which got nicked
Home > Help Needed / General Tech Chat > Cuttin' Them Damn Holes
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: