Page:
Home > Help Needed / General Tech Chat > 1st motion bearings, turbo tyoe or standard type.

daniel_johno

125 Posts
Member #: 751
Advanced Member

Aberdeen

18th May, 2007 at 12:58:32am

I have my turbo clutch housing and a standard housing ready to go to the shot blaster for a clean up.

Can i use the standard type with the smaller 1st motion bearing on my tubby engine or is the bigger turbo type needed for reliability? I will be running SC drops so the sideloading will be reduced.

The only reason i ask is i can get a standard one for £11 odd where the bigger turbo type will set me back £50 but if needs must i shall just have to dig deep.

Daniel

BENROSS

User Avatar

9812 Posts
Member #: 332
Resident Cylinder Head Modifier

Mitsi Evo 7, 911, Cossie. & all the chavs ...... won no problem

18th May, 2007 at 01:47:15am

you mean the 1st motion shaft roller nose bearing

in short yes no problems there

but if you are building a fire breathing hi boost monster then revert to the original

hope others may comment on their experiences






Vegard

User Avatar

7765 Posts
Member #: 74
I pick holes in everything..

Chief ancient post excavator

Norway

18th May, 2007 at 07:16:39am

Lots of people on here have been using the smaller one with success. Do a search, been covered before.

On 13th Jul, 2012 Ben H said:
Mine gets in the way a bit, but only when it is up. If it is down it does not cause a problem.

turbo hogster

1641 Posts
Member #: 178
Post Whore

stowmaket suffolk

18th May, 2007 at 05:35:21pm

small one every time, the bigger one seems to be a waist of money realy.

mat woods use it and never had probs in tthat particular area

always looking for them bigger bunches of bannanas
Home > Help Needed / General Tech Chat > 1st motion bearings, turbo tyoe or standard type.
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: