Page:
Home > Help Needed / General Tech Chat > Stripping Metro driveshafts/hub assembly

apollo996

86 Posts
Member #: 1240
Advanced Member

Worcester

22nd Jun, 2007 at 08:37:06am

Does anybody have any suggestions on how to release the driveshaft from the hub? I know there is a circlip you need to stretch but I seem to struggle with it. Any special tools?

Also, what size is the hub nut and is it as difficult as everybody says to undo? I'm stripping down old hubs so they aren't on the car which makes it even harder. WD40, long poles and heat I already know about.



Home > Help Needed / General Tech Chat > Stripping Metro driveshafts/hub assembly
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: