Page:
Home > Wanted > 8.4" solid discs and/or flanges

Joe C

User Avatar

12307 Posts
Member #: 565
Carlos Fandango

Burnham-on-Crouch, Essex

26th Sep, 2007 at 06:25:14pm

Hi,

I am about to do a 7.9" fiesta caliper conversion, rather than use the vented metro drive flanges, i want to try to use the std 8.4" mini flange & disc so the wheel is not moved outwards.

I'm really after the flanges, if theres discs too that'd be handy, but otherwise i'll get new discs for a tenner each.

Cheers,

Joe.

Edited by Joe C on 27th Sep, 2007.

On 28th Aug, 2011 Kean said:
At the risk of being sigged...

Joe, do you have a photo of your tool?



http://www.turbominis.co.uk/forums/index.p...9064&lastpost=1

https://joe1977.imgbb.com/



Rob H

4314 Posts
Member #: 700
Formerly British Open Classic

The West Country

26th Sep, 2007 at 10:33:33pm

I don't think the flanges effect the wheel offset, IIRC the outer face of the flange remains in the same position but the metro flanges are thinner pulling the discs out.

Isambard Kingdom Brunel said:
Nothing is impossible if you are an Engineer

Joe C

User Avatar

12307 Posts
Member #: 565
Carlos Fandango

Burnham-on-Crouch, Essex

27th Sep, 2007 at 01:28:48pm

I'm sure they do,

something like 4-5mm per side.

can anyone confirm my wrongness?

On 28th Aug, 2011 Kean said:
At the risk of being sigged...

Joe, do you have a photo of your tool?



http://www.turbominis.co.uk/forums/index.p...9064&lastpost=1

https://joe1977.imgbb.com/



pot_dan

User Avatar

928 Posts
Member #: 326
Post Whore

bradford, west yorks

29th Sep, 2007 at 07:37:50pm

i have got a set in downstairs, i will dig them out this week and let you know,

Dan

Joe C

User Avatar

12307 Posts
Member #: 565
Carlos Fandango

Burnham-on-Crouch, Essex

30th Sep, 2007 at 06:00:41pm

Ok, Cheers.

On 28th Aug, 2011 Kean said:
At the risk of being sigged...

Joe, do you have a photo of your tool?



http://www.turbominis.co.uk/forums/index.p...9064&lastpost=1

https://joe1977.imgbb.com/


Home > Wanted > 8.4" solid discs and/or flanges
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: