hogster's rolling road results
Turbo Mini Forums

well am i as happy as a dock with two dicks and a street full of lamp posts, well the arnswer has to be yyyyyyeeeeeeeeesssssss

abou time the hog started to earn it keep, after last years debarcle.

and it was the cheapest rr yet at just £26 we done 4 power runs to check the fueling which was spot for this time of year.

so the scores on the doors are as follows

10 psi 132 at the flywheel
14 psi 158
16 psi 170.1 ( notice the point 1)

the only down side is on the way home she started to smoke a tad, the temp went up a bit and started run rough.

so the worst was going through my mind, but after a quick check all plugs looked good, but checked the rad and found the water had gone below the cores and number 4 was down to 70 psi instead of 130 like the rest, so hopefully touch wood the head gasket has gone.

always looking for them bigger bunches of bannanas

wheres the pics!!!

If Carling made Mini engines
it would probably be like this one!

Good figures.

Whats the spec?

good job, amazing how we have all moved on over the years, a few years back we would have all been very happy with your 1st figure.

Hope the problem isn't too serious, what CR are you running?

Team Racing

well done hoggy .... hope its nothing bad

nice one, all working ok atlast!!!(nearly)

Good work Hogster.

Hope it's all ok though.

In the 13's at last!.. Just

cr is 8.4, 1310 turbo mega pistons, morspeed and miniwilliy head chambered to 28 cc., special grind tu4rbo cam, blue print IC , then the usaul mega jolt afv ect.

hog sccr box with ms 4 pin diff on 2.9 with 13 revolutions.


i think that abouts covers it.

i will post pic of graph and hopefully a crocked head gasket tomoz at some point.

always looking for them bigger bunches of bannanas

Nice.

What sort of revs are you doin when pulling around 70?

good power, I mean banananananas

AlexF

Yes that's so true Jim!!

BIG WELL DONE OLD BOY! so pleased for you at last.

I'm sure it's just the head gasket, just knock a couple of psi of her and she'll be find :):)

Best 1/4 mile 13.2 seconds @116 mph
First 5 port miniturbo to make over 200 bhp on a carb?
First 5 port miniturbo to make over 200 bhp on Injection?

http://www.mattwoodsphotography.com

Sadly No Pictures John, i wasn't there lol

Best 1/4 mile 13.2 seconds @116 mph
First 5 port miniturbo to make over 200 bhp on a carb?
First 5 port miniturbo to make over 200 bhp on Injection?

http://www.mattwoodsphotography.com

Edited by Turbo Tel on 29th Feb, 2008.

website:- http://www.terryhunt.co.uk

we are all trying not to think like that mate

Best 1/4 mile 13.2 seconds @116 mph
First 5 port miniturbo to make over 200 bhp on a carb?
First 5 port miniturbo to make over 200 bhp on Injection?

http://www.mattwoodsphotography.com

Great stuff mate congrats!

hope its ok hoggy !!

Medusa + injection = too much torque for the dyno ..https://youtu.be/qg5o0_tJxYM

Fingers crossed its just the gasket here too!

Very well done on the figures mate, and i too have my fingers crossed for a head gasket failure.

-MINI CLUBMAN 1380 TURBO-

hoggy ,which rr was it ?

Medusa + injection = too much torque for the dyno ..https://youtu.be/qg5o0_tJxYM

Great stuff Hogmeister.

That was some bad luck you had previously - hopefully this is just a little gasket issue!

Edited by AlexF2003 on 29th Feb, 2008.

"Turbo's make torque, and torque makes fun"

"did you know you can toast potato waffles?"

i would as well, i would like about 120-140 bhp on my minskey

Drives
-Ford S-max Mk2 Ecoboost
-Rover 100 VVC #2 - track project

Searching is all you need on TurboMinis