Brace Bars
Turbo Mini Forums

A chap in my local club has asked me if I could make him a pair of brace bars similar to what I have on my clubby, now it would be pretty simple for me to knock out a couple of sets whilst I'm at it, if anyone else is interested.

Note

1) If you mount them like I have they will probably foul on a side mounted rad, but it may be possible to mount them to clear the rad, they do however clear coilover brackets unlike some brace bars.

2) I am just looking to make and sell the brace bars along with the spherical joints (often referred to as rose joints) and spacers, you will need to make the brackets that weld onto the bulk head & subframe yourself, however these are simple to make and allow for some flexibility when mounting the bars.

3) They will be supplied in aerosol primer.

I'd be after £35 posted which is about the same as off the shelf brace bars from most mini suppliers.

PM me if you're interested.

Below are a couple of pics:

blimey rob , id have thought just the cost of 4 rose joints would be more than that !!!

Medusa + injection = too much torque for the dyno ..https://youtu.be/qg5o0_tJxYM