Page:
Home > Help Needed / General Tech Chat > edis ignition wiring

davidb

22 Posts
Member #: 2278
Member

salisbury wiltshire

28th Mar, 2008 at 11:03:31pm

im a bit stuck at the moment wiring up the edis module
as the connector that fits my edis module seems to have a different layout to the one shown on the megasquirt web site .
mine is different where the wiers for the pip signal and the saw input signal are ie. my pip sinal comes out of pin 1 but my saw signal wire goes to pin 4 and not to pin 3 on the connector
so i need a bit of help to sort out where the wires should go thanks

Turbo Tel

User Avatar

1060 Posts
Member #: 588
Post Whore

Delaware, USA

28th Mar, 2008 at 11:22:48pm

Double post....

Edited by Turbo Tel on 28th Mar, 2008.

website:- http://www.terryhunt.co.uk

Home > Help Needed / General Tech Chat > edis ignition wiring
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: