Page:
Home > Help Needed / General Tech Chat > what ratio are standard A+ rockers ?

Richie

User Avatar

3184 Posts
Member #: 628
Post Whore

a LIL fishing village on the coast - Newcastle Upon Tyne

7th May, 2008 at 07:38:16pm

as per title folks what ratio are the standard machined steel rockers ?



______________________________________________________
TRADER HALL OF FAME
BENROSS...MINIMARK..WOLFIE (comic genius).....CARL....MARTPAUL.......AXEL
______________________________________________________
TRADERS OF SHAME
1 user....pm me 4 details

LEGENDS
MikeRace, Mini13

On 17th Aug, 2009 Jay#2 said:
I doubt I'll be dipping into the 13's like you did though!

Vegard

User Avatar

7765 Posts
Member #: 74
I pick holes in everything..

Chief ancient post excavator

Norway

7th May, 2008 at 07:47:54pm

1,28:1

On 13th Jul, 2012 Ben H said:
Mine gets in the way a bit, but only when it is up. If it is down it does not cause a problem.

Richie

User Avatar

3184 Posts
Member #: 628
Post Whore

a LIL fishing village on the coast - Newcastle Upon Tyne

7th May, 2008 at 07:50:18pm

baalls no good for phase two then.



______________________________________________________
TRADER HALL OF FAME
BENROSS...MINIMARK..WOLFIE (comic genius).....CARL....MARTPAUL.......AXEL
______________________________________________________
TRADERS OF SHAME
1 user....pm me 4 details

LEGENDS
MikeRace, Mini13

On 17th Aug, 2009 Jay#2 said:
I doubt I'll be dipping into the 13's like you did though!

Vegard

User Avatar

7765 Posts
Member #: 74
I pick holes in everything..

Chief ancient post excavator

Norway

7th May, 2008 at 07:55:05pm

The pressed steel ones are the best if not going roller tip.

On 13th Jul, 2012 Ben H said:
Mine gets in the way a bit, but only when it is up. If it is down it does not cause a problem.
Home > Help Needed / General Tech Chat > what ratio are standard A+ rockers ?
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: