| Page: |
| Home > Help Needed / General Tech Chat > rocker covers | |||||||
|
621 Posts Member #: 393 Post Whore Oulton Park |
20th May, 2008 at 10:48:34pm
does everyone use standard rocker covers? i have some Ld roll rockers, and no matter where i move the cover, it sounds like the rockers are hitting the cover. tryed positioning it a few times with no joy. |
||||||
 9812 Posts Member #: 332 Resident Cylinder Head Modifier Mitsi Evo 7, 911, Cossie. & all the chavs ...... won no problem |
20th May, 2008 at 11:31:36pm
use the mg rocker cover
|
||||||
 6274 Posts Member #: 509 Post Whore Isle of Man |
20th May, 2008 at 11:35:29pm
or a pressed tin one "Turbo's make torque, and torque makes fun"
|
||||||
|
4018 Posts Member #: 1757 Back to Fucking Tool status Swindon |
21st May, 2008 at 07:26:12am
what about thoes hightop alloy rockers are they ok to use? Drives
|
||||||
 9258 Posts Member #: 123 Post Whore Betwix Harrogate and York |
21st May, 2008 at 07:40:48am
I find I have to finger tighten mine then knock it back (towards the carb) before fully tightning it. Fastest 998 mini in the world? 13.05 1/4 mile 106mph
On 2nd Jan, 2013 fastcarl said:
the design shows a distinct lack of imagination, talk about starting off with a clean sheet of paper, then not bothering to fucking draw on it,lol On 20th Apr, 2012 Paul S said:
I'm mainly concerned about swirl in the runners caused by the tangential entry. |
||||||
|
621 Posts Member #: 393 Post Whore Oulton Park |
21st May, 2008 at 04:58:57pm
alloy mini sport one nice lookin but engine sounds rough lol
|
||||||
|
6274 Posts Member #: 509 Post Whore Isle of Man |
21st May, 2008 at 05:14:58pm
in the past ive had to grind relief point in my mates rocker cover so it would clear, be carefull not to get it too hot though, if its laquered it might bubble
"Turbo's make torque, and torque makes fun"
|
||||||
| Home > Help Needed / General Tech Chat > rocker covers | |||||||
|
|||||||
| Page: |