| Page: |
| Home > Help Needed / General Tech Chat > Chopping front valance? | |||||||
 8297 Posts Member #: 408 Turbo Love Palace Fool Aylesbury |
6th Jun, 2008 at 10:44:15am
Im looking at possily chopping the corners off the front valance (just past tie rod location) would this be ok, or will it effect the structural integrity too much?
https://www.facebook.com/pages/Fusion-Fabri..._homepage_panel
|
||||||
 9258 Posts Member #: 123 Post Whore Betwix Harrogate and York |
6th Jun, 2008 at 10:53:42am
Can't see a problem. Fastest 998 mini in the world? 13.05 1/4 mile 106mph
On 2nd Jan, 2013 fastcarl said:
the design shows a distinct lack of imagination, talk about starting off with a clean sheet of paper, then not bothering to fucking draw on it,lol On 20th Apr, 2012 Paul S said:
I'm mainly concerned about swirl in the runners caused by the tangential entry. |
||||||
|
Site Admin  8506 Posts Member #: 16 Sold the turbo and seeing what the C20XE can do! Near Lincoln |
6th Jun, 2008 at 11:34:18am
no worries, on like the old stuff that had it chopped out to vent the drums |
||||||
|
8297 Posts Member #: 408 Turbo Love Palace Fool Aylesbury |
6th Jun, 2008 at 11:53:25am
Good good, I'll get chopping then! :) https://www.facebook.com/pages/Fusion-Fabri..._homepage_panel
|
||||||
 1745 Posts Member #: 375 Post Whore Leicestershire |
6th Jun, 2008 at 06:04:32pm
What are you chopping them for? Dirty big frontmount?
|
||||||
|
667 Posts Member #: 1376 Post Whore clock tower with a sniper rifle |
6th Jun, 2008 at 07:51:37pm
internationally known as "big" swede |
||||||
|
8297 Posts Member #: 408 Turbo Love Palace Fool Aylesbury |
6th Jun, 2008 at 10:06:49pm
Exactly like that! Lol
https://www.facebook.com/pages/Fusion-Fabri..._homepage_panel
|
||||||
| Home > Help Needed / General Tech Chat > Chopping front valance? | |||||||
|
|||||||
| Page: |