Page:
Home > General Chat > trying to identify a cam

robert

User Avatar

6752 Posts
Member #: 828
Post Whore

uranus

2nd Nov, 2008 at 09:09:02am


anyone seen these markings before ? it has around 400thou lift at 1.5 rocker ratio.

Medusa + injection = too much torque for the dyno ..https://youtu.be/qg5o0_tJxYM

Paul R

User Avatar

4018 Posts
Member #: 1757
Back to Fucking Tool status

Swindon

2nd Nov, 2008 at 02:05:45pm

does it have any notches on it? or just clean with nothing on?

Drives
-Ford S-max Mk2 Ecoboost
-Rover 100 VVC #2 - track project

Searching is all you need on TurboMinis


robert

User Avatar

6752 Posts
Member #: 828
Post Whore

uranus

2nd Nov, 2008 at 02:28:45pm

just clean paul , it obviously had something on the end the chap has ground off ,then stamped on his own no ,from the lift im gussing at a 270 degree sort of cam

Medusa + injection = too much torque for the dyno ..https://youtu.be/qg5o0_tJxYM

Paul R

User Avatar

4018 Posts
Member #: 1757
Back to Fucking Tool status

Swindon

2nd Nov, 2008 at 02:30:34pm

i was wondering as i have a clean cam somwhere in my other garage, may be the same cam if its a standard production cam :)

Drives
-Ford S-max Mk2 Ecoboost
-Rover 100 VVC #2 - track project

Searching is all you need on TurboMinis

Home > General Chat > trying to identify a cam
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: