Page: |
Home > Technical Chat > The 500 and 731/800 kent cams | |||||||
520 Posts Member #: 2093 Post Whore Grenoble, France |
25th Feb, 2010 at 11:00:38pm
As promised 1 year ago here (attached) is the profile of the 731 camshaft I bought in the US. I show it along with the MD266 and MD256 (both brand new) profiles. I use theoretical rocker ratio 1.25:1 (Kent use 1.28) and the valve clearance of 0.4mm must be deduced to get the advertised lifts.
Edited by alpa on 25th Feb, 2010. std 998 A+, g295, MD266, RHF4, 109hp @0.8bar/5400rpm |
||||||
7763 Posts Member #: 74 I pick holes in everything.. Chief ancient post excavator |
26th Feb, 2010 at 08:37:55am
On 7th Jan, 2009 Sprocket said:
On 7th Jan, 2009 joeybaby83 said:
dont they stretch out by about 3 degrees after a few miles? thats what has been recommended to me anyhow Chains dont streach, they wear And when they wear, the get shorter. Crikey, you're worse than me On 13th Jul, 2012 Ben H said:
Mine gets in the way a bit, but only when it is up. If it is down it does not cause a problem. |
||||||
Home > Technical Chat > The 500 and 731/800 kent cams | |||||||
|
Page: |