Page:
Home > General Chat > Exhaust Clearance Around The Pot-Joint Area

James_H

User Avatar

3692 Posts
Member #: 1833
Formally mini_majic

Auckland, New Zealand

Righto everyone.

Im just wondering, the people that have had clearance issues with exhaust of a large diameter, whether the issue was with the body or with the pot-joint itself?

If it was with the body is it where the tunnel meets the toe board?

How much extra clearance would you say you needed and for what exhaust diameter?


The reason i ask is becuase im at the point where i can chop the body around and so i would rather increase clearance now than find i want/need to do it later on.

Thank you, James.


turboestate

User Avatar

368 Posts
Member #: 362
Senior Member

durham area

well I've had a two inch down pipe in there before was a little close to the pot joint but caused no problems.

love that straight cut scream!!!
______
/___|_____
_ (@)___(@)


Miniwilliams

User Avatar

5329 Posts
Member #: 140
Proven 200+bhp & Avon Park 05,06,07 Class D 3rd place

If your engine is solid, you only need about 5mm clearence.

Best 1/4 mile 13.2 seconds @116 mph
First 5 port miniturbo to make over 200 bhp on a carb?
First 5 port miniturbo to make over 200 bhp on Injection?

http://www.mattwoodsphotography.com


apbellamy

User Avatar

16540 Posts
Member #: 4241
King Gaycharger, butt plug dealer, Sheldon Cooper and a BAC but generally a niceish fella if you dont mind a northerner

Rotherham, South Yorkshire

Tempting for a signature....


On 17th Jan, 2009 turboestate said:
I've had a two inch down pipe in there before

Edited by apbellamy on 17th Jan, 2009.

On 11th Feb, 2015 robert said:
i tried putting soap on it , and heating it to brown , then slathered my new lube on it

*hehe!*

Home > General Chat > Exhaust Clearance Around The Pot-Joint Area
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: