Megajolt V3 MAP setup. and wiring harness
Turbo Mini Forums

I have A V3 MegaJolt Lite Jr for sale (MAP not TPS)



Included is a complete wiring loom made from a full FORD harness all neat and tiday with no cut and shuts in the loom apart from the take offs for power. The Molex connector as the clip broken off but it does not affect the plug at all,it is a snug fit anyway. Also i have some spare pins that can be used if needed for the other outputs and inputs to the MJLJ. Has all the right connectors and the VR cable is shielded . Like i said before all as it was from the ford factory but with all the un-needede bits removed.

I also have a VR sensor(cant find it at the moment but it is one of the long looking ones.) included free if i find it!!

This was all running on my 998 engine before i ripped it all out.

No coil or trigger wheel.

In this picture you can see the EDIS on the left of the Bulkhead, The coil on the right and the VR sensor cable running around and past the radiator and down the front of the wing to connect.



looking for £120 ono plus postage from the USA.(which isnt that expensive)

Edited by miniboo on 23rd Jan, 2009.

down to £110 + p+p