Engine Machining Work
Turbo Mini Forums

Hi again folks. Does anyone know of a engine machining company near dudley in the west mids that can bore out my block. I've tried a few local engine centres round by where I live but they all give me roughly the same price for what I want done. Thought I'd ask you guys as one of you may of had a bargin price off another company close by me.

Do these prices look any good or can I get cheaper.

Block surface grind £30
Bored +20" and honed x4 bores £80
Piston to con rod fitting £12.50 per piston
Cylinder head unleaded conversion £130

Any advice would be fab!!!

id say thats fair tbo, considering time and wear on tooling :) and remember, you generally get what you pay for

turbo 16v k-series 11.9@118.9 :)

Denis O'Brien.

Prices seem to be about right.

lookup halesowen engines... they have done bits for me in the past

prices look ok to me- at the end of the day its the quality that matters

yep prices lookk ok to me,

last biut of machinng i had done was was a block skim, was £45 but that was to have 50 thou (1.3mm) taken off.

Well boys I've bit the bullet and took my 1275 block to the engine centre.
Chap there was sound. Doing a light surface grind (to make sure the deck is dead flat) Chemical clean and +20'' rebore and honed for..........wait for it.................£110. Woo Hoo.