Page:
Home > General Chat > mjlj success :)

Brett

User Avatar

9502 Posts
Member #: 1023
Post Whore

Doncaster, South Yorkshire

19th Aug, 2009 at 01:03:00am

just built my first mjlj v4 board and tidyed up the hard cut limiter, it was a 95% success*happy* even got comms straight away with a 16 ish yo laptop*surprised* (only one i have with a serial port)

there is a slight defect i think on my board where the RJ11 connector sits, tomorrow i am going to bypass this (or piggy back it) two of the traces are clear and go to chip U2 but where do the others go?

the top right seems to be ground and the bottom right not connected to anything (looking at the board upside down with the molex connector to the bottom)
i am too tired at the minute i will look it over again in the morning but any help is appreciated,

Brett

Yes i moved to the darkside *happy*

Instagram @jdm_brett

Home > General Chat > mjlj success :)
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: