Page:
Home > Wanted > Special Tool needed

miniswordsman

617 Posts
Member #: 6558
Post Whore

Pueblo, Colorado, USA

31st Aug, 2009 at 03:08:59pm

Hello all, I need a special tool. I'm replacing my clutch, and I need the tool that takes the primary gear off so that I can replace the oil seal behind it. No more clutch contamination! Yay.

-James

fastcarl

User Avatar

6965 Posts
Member #: 507
Fastest A Series Mini in the World

leeds/wakefield.

31st Aug, 2009 at 04:04:31pm

claw hammer

WWW.FORCE-RACING.CO.UK PLEASE CLICK HERE

miniswordsman

617 Posts
Member #: 6558
Post Whore

Pueblo, Colorado, USA

31st Aug, 2009 at 04:25:55pm

I'm assuming just be careful so as not to bugger the primary?

Joe C

User Avatar

12307 Posts
Member #: 565
Carlos Fandango

Burnham-on-Crouch, Essex

31st Aug, 2009 at 04:35:19pm

yep,

you can get a purchase where the splines start, the clutch dosent go that far up the splines anyway.

just be carful not to scratch the surface where the seal runs, bu that should be protected by the seal anyway,

On 28th Aug, 2011 Kean said:
At the risk of being sigged...

Joe, do you have a photo of your tool?



http://www.turbominis.co.uk/forums/index.p...9064&lastpost=1

https://joe1977.imgbb.com/



Rob H

4314 Posts
Member #: 700
Formerly British Open Classic

The West Country

31st Aug, 2009 at 04:35:20pm

Note I've note tried this:

I believe it's possible to remove the oil seal by screwing a self tapping screw into it and then pulling the seal out with a claw hammer.

As I said I've not tried this, I've always removed the drop gear housing when I've done the oil seal.

EDIT: I used live with a special tool but I don't think he'd be very got a replacing an oil seal.

Edited by Rob H on 31st Aug, 2009.

Isambard Kingdom Brunel said:
Nothing is impossible if you are an Engineer
Home > Wanted > Special Tool needed
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: