AP / Girling master cylinders
Turbo Mini Forums

Guys

I am trying to fit one of these and cant seem to shorten to pushrod enough to make it fit the pedal/clevis and still maintain enough throw in the pushrod to make a decent travel into the cylinder.

http://www.merlinmotorsport.co.uk/p540/GIR...oduct_info.html

Not sure I am making any sense there, but if any of you have them bolted directly to the bulkhead, any tips would be appreciated.

How far do they need to move?

Cheers

Edited by dn89mini on 20th Sep, 2009.

Check out the (slow) progress at.......
http://www.turbominis.co.uk/dn89mini

i think you might be surprised at how little travel will be needed

i bought a second hand set up off ebay a few years back, and this just had about 1" of rod protruding with the clevis welded on the end

ill try and snap a pic when next down the garage, but i think nic and a few others use these so they might be able to shed some light on it

"Turbo's make torque, and torque makes fun"

"did you know you can toast potato waffles?"

Nic has a spacer under his m/c. I made my own pushrods

Paul

I seriously doubt it!

I have a 4mm spacer and a home made clevis which is shorter than usual

Thanks guys

Check out the (slow) progress at.......
http://www.turbominis.co.uk/dn89mini