Page:
Home > Help Needed / General Tech Chat > Turbo carb washer

Amp

432 Posts
Member #: 7856
Senior Member

Essex

22nd May, 2010 at 03:28:21pm

Hey, i've done a search but can't find what i'm after! I'm rebuilding my turbo carb and i only have 1 of these washers that goes on the end of the throttle spindle, outwards of the seal, is this needed? If so would a metal one suffice? I cannot find anywhere that supplies them and Burlen can't find any mention of them on the specification for the carbs, any ideas? Cheers :)

Edited by Amp on 22nd May, 2010.

Home > Help Needed / General Tech Chat > Turbo carb washer
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: