Page:
Home > Help Needed / General Tech Chat > bulkhead box fitting

clubminiflip

User Avatar

1840 Posts
Member #: 54
Post Whore

nr coventry

5th Nov, 2003 at 04:10:33pm

i'm about ready to cut my bulkhead to fit a turbo bulkhead box, i know it sounds a dim question but, whats the best tool to use for this job? any hints and tips would be a good help and should it be about 50mm to the right from the brake and clutch mouting area much thanks from dave

SKYLINES ARE LIKE CLITS, EVERY FLANGE SEEMS TO HAVE ONE: see this sticker on my silvia

the Search-section on this forum is blummin superb & simple to use, unlike some other forums, without the search-section & the help of this bunch of chaps on here i'll never be able to !!!Start the day with a 998cc turbo!!! :) i'm getting closer though!

Tom Fenton says: I have it all, make me an offer

Gibbo

244 Posts
Member #: 34
Senior Member

6th Nov, 2003 at 09:57:32am

9" angle grinder.

Were you having problems with those rusty tin snips you found on your garage floor *tongue*

Must be resonable close to the clutch cylinder, and remember to make a angled cut on the right hand side big enough to allow space for the actuator.

Take a look around this site and you'll find links with pictures of other peoples cars.

Edited by Gibbo on 6th Nov, 2003.

Home > Help Needed / General Tech Chat > bulkhead box fitting
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: