bolts and bits
Turbo Mini Forums

hi guys and girls,
i have a few questions i would like some help,

1. i put my turbo engine in my mini front end has been cut off, and when it come to fitting the brake servo the breather was in the way or vice versa, whats the deal there?

2. i fitted the servo anyway because i didnt want the pipes getting broken i went to fit the servo to the foot pedal section i imagine the bolt would be in a plastic type of sheath with a split pin if so where do i get them from.

3.is this the same for the linkage between the gear stick and engine the top one of two i have done the bottom.

thanks for reading, sean.

1 - You can either modify your one with a hammer so it fits, or you can do it properly and buy one of these:

http://www.minispares.com/Product.aspx?ty=...id=41641&title=

2 - Minispares stocked them but are now out, maybe try emailing them?

http://www.minispares.com/Product.aspx?ty=...id=34270&title=

3 - Assuming you mean the roll pin, no it's different! I can't think what else you mean as the linkage is only held on with these pins and the 2 rubber mounts?

http://www.minispares.com/Product.aspx?ty=...id=33618&title=

In order to be fair, there will be other suppliers out there but Minispares have done me fine :)

nice one thanks hit the nail right on the head.
as for number three i got those that you showed me thats the bottom rod if right the top one looks like it needs to be about two inchs or so long.
thanks again

Oh sorry yeah i know what you mean, i was just being "special" i'll have a look in a bit for you

Are you sure it's not meant to be a bolt? It's been a while since i last had mine off

Edited by Amp on 30th Jul, 2010.

I have one of these you can have look in the forsale forum for transfer case breather.

Own the day