inertia switch mounting?
Turbo Mini Forums

got a few inertia switches today out of mondeos, from the breakers..

where do you guys recommend fitting them or where have you fitted them?

and just to check, do they wire up inline with the fuel pump + connection?

cheers,
adam.

Edited by adam1330 on 6th Mar, 2005.

““A turbo: exhaust gasses go into the turbocharger and spin it, witchcraft happens and you go faster.”” - Jeremy Clarkson

i'd fit it in the same place as where you removed them

i'd imagine you could wire up through the relay for the pump for sure, don't know about on the actual +ve connection, i'm sure someone else can confirm this

Mount it somewhere solid, the bulkhead is the best place, just make sure you can get to it easily
Connect it inline with the feed to your fuel pump/fuel pump relay

Adam, Where do I look for an inertia switch on a Mondeo? Im hopefully going to the scrappies at the weekend.

Cheers

Yes, Im getting there.....

www.itsmuckingfagic.com

All fuel injected Fords have them in either the left, or right, A-Pillar. Mondeos are on the left hand pillar, just above where the bottom hinge is. I mount mine onto the pedal box - but any point on the bulkhead will suffice!
They aren't high current - so you need to wire them via a relay.

the ford ones are high current IIRC dave, or atleast the one i got i reckon was.

Then again could be talking rubbish!!

I stand corrected then! LOL!

not until ive got proof you dont!