What size reamer?
Turbo Mini Forums

Anyone know what size reamer do I need for rocker bushes?

Cheers!

In the 13's at last!.. Just

I'm guessing it was too small?

http://cgi.ebay.co.uk/Adjustable-Reamer-9-...=item4cf5fb2a12

http://cgi.ebay.co.uk/Expanding-reamer-/12...=item1c1a5a582a

http://www.chronos.ltd.uk/acatalog/Economy...32---23-32.html

ref 829372P71


http://www.rdgtools.co.uk/acatalog/ADJUSTA...DUAL_SIZES.html

Quite the opposite. I read somewhere that a 5/8 was needed, but after a quick measure, this would virtually remove the bush from the rocker.

Cheers for the links. :)

In the 13's at last!.. Just

yeah, got a bit carried away there lol.

I was expecting that the one you got would be 9/16 (562.5thou) my shaft seems to be a bit bigger than 9/16, so I'd deffo go for an adjustable reamer, you can get them nice and snug then,

adustables chatter a bit more than normal reamers, so I'd advise doing them by hand, should be easy on the soft bushes though, My rods reamed out ok bu hand.

Cool. I'll order one for future use. I was going to do it tomorrow and swap the gasket. I'll see if a local shop can do them.

Otherwise I'll get roped into helping Paul out!

In the 13's at last!.. Just

LOL

give me a bell if your at pauls, I'll be doing a minispares run so can drop by.

Got those tyres pumped up yet...

What size reamer do you need for the rear radius arms

Yup, all full of air and on the car!

I'll get them balanced once I've sorted the rockers.

I'll be there at some point after 5 :)

In the 13's at last!.. Just

Yup, all full of air and on the car!

I'll get them balanced once I've sorted the rockers.

I'll be there at some point after 5 :)

In the 13's at last!.. Just