Straight cut gear cut - remote change
Turbo Mini Forums

Hi i have a gearset for a remote change gearbox.

WILL NOT FIT rod change - hence why i'm selling it.

I'll put pics up on Tuesday when it comes back from my engine builder.

£250 or offers

If you will take 200 + post to Ireland I will take it regards Paul.

If youll post to aus then im interested. What condition are they in?

In boost we trust

Which make is it?

Guys, i'm getting them back tomorrow so i'll be able to take photos and find out what make.

Gents, i got my gearset back today and was able to take a few pics and ask some more questions.

I'll freely admit i dont know masses about gearboxes.

Its a remote change gear kit and uses a different layshaft tapered rather than step change.

unknown make but my engine builder who has been building race minis for the last 40 years, thinks they might be an original spec item.

4 synchro, very little if any use all teeth look perfect there are the following numbers stamped on the gears

E-3A103
E-3A104
E-3A105

I hope that means more to you than it does me.

As said above i'm looking for around £250.

Attachments:

918.58kb

1023.24kb

I cannot understand why you claim that it's a remote change set based on those pictures.

That looks very rod change to me have you got a picture of reverse gear ideler

Isn't the reverse gear idler the only thing that changed when the selector type changed? As that doesn't seem to be present I can't see how you can tell.

Exactly people!

If its pre A+ it wont go into an A+ case without modification. This could be causing the confusion

I seriously doubt it!

Well goes to show how much i know about gearboxes

Got a call earlier to say that he's found my reverse gear.

I'll put a picture of that up when i get it back.

Dont berate me too much guys i'm trying to be as honest as i can here. I dont want to sell it under any misinformation