Page:
Home > Help Needed / General Tech Chat > 16v piston cut outs

turbo1312

User Avatar

54 Posts
Member #: 64
Advanced Member

1st Nov, 2011 at 11:27:23am

Hi guys,

How deep do I need to make piston cutouts for non interference 1293cc engine with k1100 16v head and rs cams

thanks...

NickG

744 Posts
Member #: 7912
Post Whore

Australia oi oi oi!

1st Nov, 2011 at 12:00:31pm

5.5 mm from memory/ talking to people about this conversion and with alot of clearance to clear valves.

i could be totally wrong just what i have been told.

Edited by NickG on 1st Nov, 2011.


Sprocket

User Avatar

11046 Posts
Member #: 965
Post Whore

Preston On The Brook

1st Nov, 2011 at 12:38:58pm

Install the cams in the head, and set the valves at full lift, then measure, simple. Add a little for clearance, The gasket will then provide the rest of any clearance to give you a clearnace type engine.

Question is, are you worried about timing belt failure?

On 26th Oct, 2004 TurboDave16v said:
 Is it A-Series only? I think it should be...
So when some joey comes on here about how his 16v turbo vauxhall is great compared to ours, he can be given the 'bird'...


On 26th Oct, 2004 Tom Fenton said:
Yep I agree with TD........
Home > Help Needed / General Tech Chat > 16v piston cut outs
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: