primary gear to clutch assembly order
Turbo Mini Forums

hi all,

i took my engine apart well over 1 1/2 years ago and i cannt remember the order on the end of the crank shaft.

Can anyone help? its a verto assembly i looked and cant see anthing on here or on on other sites

can any body give me the order and some pics??

cheers

It goes:

thrust washer against crank shoulder (tapered side against crank)
primary gear
thrust washer
'C' retaining ring
Clutch oil seal (if not already fitted)
Dust seal (slides over splines of primary gear, sits against clutch oil seal)

Flywheel
clutch plate
carrier with hub
key'd washer
flywheel bolt
Clutch sleeve
release bearing/Wok assembly

Edited by matty on 10th Jan, 2012.

https://www.facebook.com/pages/Fusion-Fabri..._homepage_panel

www.fusionfabs.co.uk



1/4mile in 13.2sec @ 111 terminal on 15psi

Thank you very much I missed out one of the thrust washers I glad I asked :)

Thanks for your help

Remember to check the clearance between the end of the primary gear and second thrust washer.

Edited by matty on 10th Jan, 2012.

https://www.facebook.com/pages/Fusion-Fabri..._homepage_panel

www.fusionfabs.co.uk



1/4mile in 13.2sec @ 111 terminal on 15psi

Sorry to be a pain, how do I know which thrust I need? Is it determined by the end float of primary gear

Cheers for your help matty

Edited by Rickus on 10th Jan, 2012.

what does the thrust washer look like that goes against the primary gear?

This is the one that goes before the primary gear. You need to fit one, then using a feeler gauge measure the gap between the end of the primary gear and the second thrust washer. If the endfloat is wrong order the right width thrust washer to correct the gap.

https://www.facebook.com/pages/Fusion-Fabri..._homepage_panel

www.fusionfabs.co.uk



1/4mile in 13.2sec @ 111 terminal on 15psi

I thought so the second thrust is that the c clip back plate or the gear housing itself

I'm prob just being stupid lol
Cheers again

Backplate?

Yeah the C clip 'back plate'.

https://www.facebook.com/pages/Fusion-Fabri..._homepage_panel

www.fusionfabs.co.uk



1/4mile in 13.2sec @ 111 terminal on 15psi

Ok that's brill, thank you again Matty.