One pair of T45 steel lightweight rear radius arms
Turbo Mini Forums

Clearing my garage loft out in readiness for some building work, the things you stumble across...

I didn't even realise I had these up there until getting well through the piles of mini stuff accumulated

They are T45 steel tube/EN16T turned parts/CR4 sheet parts. The T45 was laser cut to form the fish mouths and they were jig mounted and assembled before being powder coated. The thick wall T45 where the pivot pin sits was machined internally ready for the needle roller bearings, you can see these in one of the pics. They weigh 1.805kg each as shown - without pivot pin and stub axle. Not so clear in the pics, they do have tubes to take the quadrant pin for the handbrake pin.

No use to me now other than ornaments, so offering them to the TM guys for £130 - will take to Bingley next weekend, or they'll go back in the loft for another 10 years!

cheers

JohnK

If Carling made Mini engines
it would probably be like this one!

I'd take these were I not awaiting blingier suspension parts!

i know it sounds illy but what else will i need to fit these... i like the sound of them

Nothing special mate, just a direct swap for the standard ones. Ive got a set on mine,lol if i had some spare cash id have a spare set

rick

Jamz - you'll need a set of rear coil over shocks to compliment them.

James

JK

If Carling made Mini engines
it would probably be like this one!

Sold

If Carling made Mini engines
it would probably be like this one!

Ahh John you always sell the good stuff, did you make these? If not where are they from?

George