Steering Wheel Boss Bolts
Turbo Mini Forums

Hopefully thing is gonna be pretty easy one.

I have this lil beauty http://www.demon-tweeks.co.uk/motorsport/s...ouring-car-boss

Does anyone know what is the standard size for the countersunk bolts that i am supposed to use, m6? At the moment i have a mountey boss with a momo steering wheel on it but i'm not even sure what size they are :/

Any help would be greatly appreciated.

Regards

T

also notice the steering wheel side isnt threaded so will have to use longer ones and nuts

Measure the holes? If it is a plain hole (not threaded) there is your size. If it is a tapped hole then the hole will be smaller than the thread, by the pitch. So an M6 tapped hole will measure 6mm minus 1mm pitch = 5mm hole.

thanks tom, i didnt think of that such a plank.

I use AHC on the A30. They do stainless cap and dome head screws. Sell them individually too.

Some may say pedantic but I would not use stainless screws on the steering wheel. Look at what any of the big names supply and you will find 10.9 grade unplated countersunk screws.

not pentantic i dont want them snapping so i was going to get high ten 10.9 grade :)

plus i hate shiney shiney and if i'm going to be looking at it!