| Page: |
| Home > Help Needed / General Tech Chat > Safety Devices roll cage won't fit?! | |||||||
|
8 Posts Member #: 9672 Junior Member Nottingham |
25th Mar, 2012 at 05:29:15pm
As the title says, my new roll cage doesn't fit properly. We ratchet-strapped it up and squeezed it just enough to fit it in, but the two rear feet are too narrow and miss the wheel arch once we'd released the straps (the front two feet sit nicely in the bins). Is this a common problem or have I got a duff one? And I would be greatful for any solutions :) See pics below:
|
||||||
|
756 Posts Member #: 1355 Post Whore Leicester |
25th Mar, 2012 at 05:38:14pm
i think there all like that.
|
||||||
|
4018 Posts Member #: 1757 Back to Fucking Tool status Swindon |
25th Mar, 2012 at 06:57:30pm
Weld a bar on for harness, making sure it makes it easyer to fit Drives
|
||||||
 8215 Posts Member #: 90 Post Whore Somewhere around Swindon |
25th Mar, 2012 at 07:56:00pm
i bought rollcentre and the fit was far better than that Crystal Sound Audio said:
Why wolfie...you should have your name as Fuckfaceshithead ! "A common mistake that people make when trying to design something completely foolproof is to underestimate the ingenuity of complete fools."-Douglas Adams |
||||||
 8297 Posts Member #: 408 Turbo Love Palace Fool Aylesbury |
25th Mar, 2012 at 08:35:18pm
On 25th Mar, 2012 jameswildcooper said:
i think there all like that. mine was. you have to put your back up against one post and push other out with your foot while someone drills holes out for it. This is what I would do. ^^^^ It might be the case that the ratchet strap was too tight and its no sprung back fully? 
https://www.facebook.com/pages/Fusion-Fabri..._homepage_panel
|
||||||
 3673 Posts Member #: 9300 Post Whore Quarry Bonk |
25th Mar, 2012 at 08:51:11pm
Last time i fitted one, I had to push it apart as described above. Complete pita. On 26th Jan, 2012 Tom Fenton said:
ring problems are down to wear or abuse but although annoying it isn't a show stopper On 5th Aug, 2014 madmk1 said:
Shit the bed! I had snapped the end of my shaft off!! 17.213 @ 71mph, 64bhp n/a (Old Engine) |
||||||
 869 Posts Member #: 2443 Post Whore Cheshire |
25th Mar, 2012 at 08:59:38pm
Ditto above |
||||||
 7765 Posts Member #: 74 I pick holes in everything.. Chief ancient post excavator |
26th Mar, 2012 at 07:28:56am
On 25th Mar, 2012 Paul R said:
Weld a bar on for harness, making sure it makes it easyer to fit  Don't weld a Safety Devices cage, It'll void the FIA-approval. On 13th Jul, 2012 Ben H said:
Mine gets in the way a bit, but only when it is up. If it is down it does not cause a problem. |
||||||
| Home > Help Needed / General Tech Chat > Safety Devices roll cage won't fit?! | |||||||
|
|||||||
| Page: |