small bore core plugs
Turbo Mini Forums

I got some from minispare bu they seem too small? I have push them out with my finger... I will contact minispares but just wondered if there are different sizes? I ordered these as i have a 998 pre A+ block.

http://www.minispares.com/product/Classic/...k%20to%20search

This engine build stuff is a PITA

Thanks all...

Edited by gr4h4m on 24th Feb, 2013.

I run a supercharger and I don't care the TB is on the wrong side.
VEMS + 12 PSI + Liquid Intercooler = Small Bore FUN!

Ahh am I being stupid are you surposed to use a small socket as a drift in the middle to flatten them out a push them into the hole? I.e beinding the middle.

The seem flatter on my current engine...

I run a supercharger and I don't care the TB is on the wrong side.
VEMS + 12 PSI + Liquid Intercooler = Small Bore FUN!

Hold them in place and give them a tap in the middle with a hammer - it deforms them enough to stay in place.
Might dribble a tad on startup, but it soon stops as they furr up...

Metric is for people who can't do fractions.

I've got one leaking and kept looking at the new one thinking something is wrong!

I watched someone fitting on on youtube, They recommend putting non setting compound around the edge and hitting it in with a socket. Still must do mine, IMM is on the way!!

Thanks all. I ill put a little sealant and give the middle a tap.

I run a supercharger and I don't care the TB is on the wrong side.
VEMS + 12 PSI + Liquid Intercooler = Small Bore FUN!