Page:
Home > Help Needed / General Tech Chat > Nippon denso alternator thread

bakker110

313 Posts
Member #: 9367
Senior Member

Derby

24th Mar, 2013 at 08:21:28pm

Just wondering if anyone knows the thread of the threaded hole in these alternators. I've just tried an m8 bolt which semi goes in but felt tight after a turn or two. I was just wondering if it was an unusual pitch or something.

Also on the same subject the size of the bolt that the bottom side bracket usually bolts to on the timing back plate. And does this come out?

Cheers

Joe C

User Avatar

12307 Posts
Member #: 565
Carlos Fandango

Burnham-on-Crouch, Essex

24th Mar, 2013 at 08:35:48pm

the four Ive had were normal M8. probably just shit in the thread

On 28th Aug, 2011 Kean said:
At the risk of being sigged...

Joe, do you have a photo of your tool?



http://www.turbominis.co.uk/forums/index.p...9064&lastpost=1

https://joe1977.imgbb.com/



bakker110

313 Posts
Member #: 9367
Senior Member

Derby

24th Mar, 2013 at 08:44:04pm

Ok I'll just wind in in with a spanner then instead of by hand.


Joe C

User Avatar

12307 Posts
Member #: 565
Carlos Fandango

Burnham-on-Crouch, Essex

24th Mar, 2013 at 08:49:57pm

bit of oil too!

On 28th Aug, 2011 Kean said:
At the risk of being sigged...

Joe, do you have a photo of your tool?



http://www.turbominis.co.uk/forums/index.p...9064&lastpost=1

https://joe1977.imgbb.com/


Home > Help Needed / General Tech Chat > Nippon denso alternator thread
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: