Page:
Home > Help Needed / General Tech Chat > Driveshaft gaiters

PEP

327 Posts
Member #: 1145
Senior Member

North Wales

29th Apr, 2013 at 03:48:59pm

Im looking to get a set of inners and outers. Just wondering what you boys were to say about them. GENUINE FROM MINISPARES ETC OR GO TO A LOCAL STORE-IE;, UNIPART ETC?????

IS IT WORTH GETTING CHEAP ONES OR IS THERE NO DIFFERENCE????

THANKS FOR THE ADVICE.*smiley*

Rob Gavin

User Avatar

6729 Posts
Member #: 618
Post Whore

Glasgow

29th Apr, 2013 at 05:27:57pm

I'd try and get quality ones. The cheap ones tend to split after 3.5 minutes of use

Cables69

User Avatar

178 Posts
Member #: 10196
Advanced Member

29th Apr, 2013 at 05:55:07pm

I would too, but ive noticed modern rubber doesnt last as long as the old stuff :(

wil_h

User Avatar

9258 Posts
Member #: 123
Post Whore

Betwix Harrogate and York

29th Apr, 2013 at 06:02:06pm

I have Subaru Legacy ones on my inners. Great quality and happened to be the right size (had them spare).

I wonder if pot joint size and drive shaft size is similar on other cars that you might be able to get good quality ones for.

Fastest 998 mini in the world? 13.05 1/4 mile 106mph



On 2nd Jan, 2013 fastcarl said:
the design shows a distinct lack of imagination,
talk about starting off with a clean sheet of paper, then not bothering to fucking draw on it,lol

On 20th Apr, 2012 Paul S said:
I'm mainly concerned about swirl in the runners caused by the tangential entry.

Home > Help Needed / General Tech Chat > Driveshaft gaiters
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: