1293 Freshly built, never run.
Turbo Mini Forums

1293 MPI engine, professionally built, never fitted or run, built by Vmax Scart Racing for a customer for a forced induction installation. Reground crank and mains, new bearings. Omega 1015, +20” 10cc cast pistons fitted to std A+ rods. Bottom end all assembled. lightened and balanced. Swiftune SW5 Cam fitted with new cam bearings and timed in. New oil pump, duplex timing gear, core plugs etc. Cylinder head is an MPI type again, ported and chambered, heat treated stainless valves, bronze guides, double springs. 35.7x29mm valves, I am not certain of the chamber volume at this time but I can try to measure.

Head is removed from the block at the moment for inspection.

This engine was built at a cost of in excess of £2000, the head alone would cost £480 + £120 exchange. I am looking for a quick sale at £1200. I could possibly deliver in the South East by arrangement and for a very reasonable delivery cost. Any inspection welcome, questions answered to the best of my knowledge. The engine is currently in Eastbourne on the South Coast.

​If you would like pictures please pm with an email address for now, I'll get some up on here as soon as I move them across from my phone.

Edited by paul1275s on 31st May, 2013.

Hi Paul,

Omega 1015 +20 10cc is a cast piston as used by many people on this forum including myself.

If something is worth doing, it's worth doing half of.

Ok, sorry, my bad, I will amend the advert and reduce the price accordingly.