Page:
Home > Help Needed / General Tech Chat > Turbo piping

jamiestevenbell

336 Posts
Member #: 9941
Senior Member

Derby

6th Jun, 2013 at 07:28:02pm

I have been looking around on here the last few days for advice on the piping of the dump valve and bits. My questions are,
1. I have a recirculating dump valve I understand the 1 inch connections go from plenum to air inlet pipe but there's a 4mm connection on the top of it where does this go to?
2. I have a stack boost gauge where abouts do I connect this in? Between the bleed valve and actuator or between turbo and bleed valve or into megajolt pipe?
Any help is much appreciated

Turbo Phil

User Avatar

4634 Posts
Member #: 20
My sister is so fit I won't show anyone her picture

Lake District

6th Jun, 2013 at 08:25:57pm

The little end of the dump valve needs connecting to the inlet manifold. The boost gauge also needs connecting to the inlet manifold.

Phil.

WWW.TURBO-MINI.COM


jamiestevenbell

336 Posts
Member #: 9941
Senior Member

Derby

6th Jun, 2013 at 10:27:40pm

Ok that's great thanks
Home > Help Needed / General Tech Chat > Turbo piping
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: