Donations towards server fund so far this month.

 
£0.00 / £100.00 per month
Page:
Home > General Chat > subframe brace bars

tony 69

134 Posts
Member #: 10548
Advanced Member

chesterfield

Hi all just a quick question has anyone had to bend there subframe brace (support) bars to get a tight fit against the inner wing.

When I bolt mine to the subframe my rear bolt hole at the inner wing is against the inner wing but the front hole is about 5/10 mm away.
Its the same on both sides so don't think anything is bent on either the car or the braces.

Thanks Tony


adcyork

User Avatar

539 Posts
Member #: 6807
Post Whore

York

No two cars are exactly the same. A slight tweak won't cause the bars any harm.


tony 69

134 Posts
Member #: 10548
Advanced Member

chesterfield

Ok mate thanks for the replie I'll give them a little nudge then

Thanks again

Home > General Chat > subframe brace bars
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: