Problem with my hole
Turbo Mini Forums

Altering the heritage inner wing back to original but unsure what these holes are for? Any help much appreciated

To bolt things to ?

9.85 @ 145mph
202mph standing mile
speed didn't kill me, but taxation probably will

Lower small holes look like the ones for the solenoid. The front one i first thought was wiring but i think it all runs through the front panel? The larger 4 im not sure. Berhsps something to do with the later ecu cars?

What things?

Best title for a thread

are they to do with the air condition system on late cars

everybody likes free stuff

Did some cars not have the washer bottle bolted there ?

9.85 @ 145mph
202mph standing mile
speed didn't kill me, but taxation probably will

the top 4 are for a wcher botle. my 1991 mini had one there

you can do anything if you set your mind to it...
i rather blow it up winning than keep it together losing.

finish date set for project 1... march 2018

Washer bottle normally has the little slider bit welded where the two lower of the '4' holes are.. but not for top 2? The little hole towards front has been on lots of my minis but never actually used for anything??? I reckon the top holes are for the later ecu brackets

Thanks for the comments, looks like I don't need them then so I will weld them up

No bonnet support thingy there either ?

9.85 @ 145mph
202mph standing mile
speed didn't kill me, but taxation probably will

Thanks for the heads up, it's ready to weld on not got round to it yet though.

strange, the top holes aint for an ecu bracket though, the front top bolt is only about 2/3 inches back from the front panel right in the curve

also a later wing would have an extra hole above the front centre ones, a small t shaped section on the rear one and a load of really small holes in a cluster in front of the crossmember, I've put them on for you, not to scale though lol

IMG_20150309_211801 by smithsonmorris, on Flickr

On 5th Oct, 2014 Shauna said:
What that's crazy, you go commando hahaha! How heavy is your helmet ?

Feckin hilarious! Very clever.. was actually properly thinking before scrowling down haha

On 10th Mar, 2015 oli79 said:
strange, the top holes aint for an ecu bracket though, the front top bolt is only about 2/3 inches back from the front panel right in the curve

also a later wing would have an extra hole above the front centre ones, a small t shaped section on the rear one and a load of really small holes in a cluster in front of the crossmember, I've put them on for you, not to scale though lol

IMG_20150309_211801 by smithsonmorris, on Flickr

Haha nice work as usual

On 10th Mar, 2015 oli79 said:
strange, the top holes aint for an ecu bracket though, the front top bolt is only about 2/3 inches back from the front panel right in the curve

also a later wing would have an extra hole above the front centre ones, a small t shaped section on the rear one and a load of really small holes in a cluster in front of the crossmember, I've put them on for you, not to scale though lol

IMG_20150309_211801 by smithsonmorris, on Flickr