Page:
Home > Help Needed / General Tech Chat > standard turbo needle on 266 cam?

Craigie-B

User Avatar

1492 Posts
Member #: 9468
Post Whore

Wootton Bassett

13th Mar, 2015 at 12:10:11pm

Hi guys,

Looking to run a standard t3 turbo setup with a 266 cam but on a 1380 forged bottom end. I have a thicker head gasket 075" to lower cr what I want to know is this

Will I get away with a standard needle for a little bit or is it going to be massively out on the fuel tune?

Thanks

On 10th Mar, 2012 theoneeyedlizard said:
Hypothetically speaking, where would you stick your nozzle?


On 22nd Jun, 2012 apbellamy said:
my wife doesn't know what.head is never mind compression ratio.

gr4h4m

User Avatar

4890 Posts
Member #: 1775
Post Whore

Chester

13th Mar, 2015 at 01:06:17pm

There's no getting away with fueling and timing on a boosted engine

I run a supercharger and I don't care the TB is on the wrong side.
VEMS + 12 PSI + Liquid Intercooler = Small Bore FUN!


apbellamy

User Avatar

16540 Posts
Member #: 4241
King Gaycharger, butt plug dealer, Sheldon Cooper and a BAC but generally a niceish fella if you dont mind a northerner

Rotherham, South Yorkshire

13th Mar, 2015 at 06:24:06pm

get a bca needle, will be rich as fuck but safe.

On 11th Feb, 2015 robert said:
i tried putting soap on it , and heating it to brown , then slathered my new lube on it

*hehe!*
Home > Help Needed / General Tech Chat > standard turbo needle on 266 cam?
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: