Page:
Home > Help Needed / General Tech Chat > GT17 actuator boost pipe feed

JT

User Avatar

2742 Posts
Member #: 637
Post Whore

Hertfordshire

7th Feb, 2016 at 11:29:19am

Hi

I've put all the turbo bits on the engine while its on the bench to check for clearance etc etc.

The turbo air feed pipe is too close to the actuator boost pipe on the turbo. I basically am asking you guys if you know the thread size on the turbo end of the actuator pipe. So I can get a 90 degree one.

Hope that all makes sense! I'll try and get a pic up later


Regards,
Josh

My build thread..

http://www.turbominis.co.uk/forums/index.php?p=vt&tid=542985

apbellamy

User Avatar

16540 Posts
Member #: 4241
King Gaycharger, butt plug dealer, Sheldon Cooper and a BAC but generally a niceish fella if you dont mind a northerner

Rotherham, South Yorkshire

7th Feb, 2016 at 01:02:27pm

1/8 bsp on the one we had.

On 11th Feb, 2015 robert said:
i tried putting soap on it , and heating it to brown , then slathered my new lube on it

*hehe!*

JT

User Avatar

2742 Posts
Member #: 637
Post Whore

Hertfordshire

7th Feb, 2016 at 06:15:27pm

ok thanks andy.
Did you need a 90 on there as well then?

My build thread..

http://www.turbominis.co.uk/forums/index.php?p=vt&tid=542985

apbellamy

User Avatar

16540 Posts
Member #: 4241
King Gaycharger, butt plug dealer, Sheldon Cooper and a BAC but generally a niceish fella if you dont mind a northerner

Rotherham, South Yorkshire

7th Feb, 2016 at 08:45:03pm

Nope, it was in a metro on a t3 manifold.

On 11th Feb, 2015 robert said:
i tried putting soap on it , and heating it to brown , then slathered my new lube on it

*hehe!*
Home > Help Needed / General Tech Chat > GT17 actuator boost pipe feed
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: