| Page: |
| Home > Help Needed / General Tech Chat > Machining | |||||||
|
12 Posts Member #: 413 Member Ontario, Canada |
13th Oct, 2005 at 10:53:30pm
Hey guys know it, build it, drive it |
||||||
  4436 Posts Member #: 164 The Stig.. Newport Pagnell |
14th Oct, 2005 at 08:46:17am
Rebore 20 thousanths of an inch over standard. On 21st Jan, 2011 fastcarl said:
therefore acheiving two things , a sore knob and a beer bellyl |
||||||
|
Site Admin  8506 Posts Member #: 16 Sold the turbo and seeing what the C20XE can do! Near Lincoln |
14th Oct, 2005 at 10:11:49am
I was going to put that |
||||||
 7765 Posts Member #: 74 I pick holes in everything.. Chief ancient post excavator |
14th Oct, 2005 at 01:41:39pm
And have the deck of the block skimmed! On 13th Jul, 2012 Ben H said:
Mine gets in the way a bit, but only when it is up. If it is down it does not cause a problem. |
||||||
|
12 Posts Member #: 413 Member Ontario, Canada |
14th Oct, 2005 at 02:00:36pm
Thanks
know it, build it, drive it |
||||||
 8215 Posts Member #: 90 Post Whore Somewhere around Swindon |
14th Oct, 2005 at 05:06:17pm
vizards?
Crystal Sound Audio said:
Why wolfie...you should have your name as Fuckfaceshithead ! "A common mistake that people make when trying to design something completely foolproof is to underestimate the ingenuity of complete fools."-Douglas Adams |
||||||
|
5795 Posts Member #: 80 AFRacing LTD Newbury, Berks |
15th Oct, 2005 at 06:52:18pm
haynes?
AlexF |
||||||
| Home > Help Needed / General Tech Chat > Machining | |||||||
|
|||||||
| Page: |