Page:
Home > Help Needed / General Tech Chat > Web details for Jack Knight ?

Richie

User Avatar

3184 Posts
Member #: 628
Post Whore

a LIL fishing village on the coast - Newcastle Upon Tyne

11th Nov, 2005 at 02:27:42pm

as per title folks i am after web details for Jack Knight, as i need a bearing to put my new turbo challenge sc gears in...i take it is the end bearing (drop gear end) that is different.... just need to order one as all

cheers

Richie.



______________________________________________________
TRADER HALL OF FAME
BENROSS...MINIMARK..WOLFIE (comic genius).....CARL....MARTPAUL.......AXEL
______________________________________________________
TRADERS OF SHAME
1 user....pm me 4 details

LEGENDS
MikeRace, Mini13

On 17th Aug, 2009 Jay#2 said:
I doubt I'll be dipping into the 13's like you did though!

BENROSS

User Avatar

9812 Posts
Member #: 332
Resident Cylinder Head Modifier

Mitsi Evo 7, 911, Cossie. & all the chavs ...... won no problem

11th Nov, 2005 at 03:16:25pm

hi richie *happy*

if its the first motion shaft bearing
there are two the smaller type and the turbo one
you can get this from minispares north ask for richard

they are not cheap though around 39 quid

when i came through i explained that you could salvage this bearing if it was in good order!

which if i remember it was !*happy*

you need to remove all the rollers & then ttease the plastic cage off leaving you with the inner race still fixed

then get a small puller you may have to mod this by sliming the ends down with the trusty grinder inorder to get this at the back of the inner race of the bearing.
& draw this off!

Remember rich you have got to have the turbo clutch cover for the larger bearing!

good luck*smiley*

p.s. rich thanks for the directions *wink*
navigation is not my forte!!!

Edited by BENROSS on 11th Nov, 2005.






Jimster
Site Admin

User Avatar

9408 Posts
Member #: 58
455bhp per ton
12 sec 1/4 mile road legal mini

Sunny Bridgend, South Wales

11th Nov, 2005 at 05:10:49pm

Richie, the bearing is a strange size, it's not the same as a series, a+, or dog box, I've tried them all. But if you give JKD a call with sizes, they will sort you.

http://www.jackknight.co.uk/

Team Racing

On 15th May, 2009 TurboDave said:
I think the welsh one has it right!


1st to provide running proof
of turbo twinkie in a car and first to
run a 1/4 in one!!

Is your data backed up?? one extra month free for all Turbo minis members, PM me for detials

BENROSS

User Avatar

9812 Posts
Member #: 332
Resident Cylinder Head Modifier

Mitsi Evo 7, 911, Cossie. & all the chavs ...... won no problem

11th Nov, 2005 at 08:55:20pm

enlightend again!*blush*

andeh

User Avatar

982 Posts
Member #: 97
Post Whore

Near Daventry, midlands

12th Nov, 2005 at 12:33:52pm

if you have one that fits, maybe an old U/S one, take it to a bearing supplier and they will be able to supply you with either a direct replacement or similar bearing.

I've seen the future and tbh its Pie

Home > Help Needed / General Tech Chat > Web details for Jack Knight ?
Users viewing this thread: none. (+ 1 Guests)  
To post messages you must be logged in!
Username: Password:
Page: